ALFA OKIPAGE 20 - Manual (Page 40)

E–32 Chapter 4: The Front Feeder
Manual Feed: Transparencies
Important! Transparency must withstand the fusing process heat of
392°F (200°C) for 1 second without wrinkling or gumming
up.
• Use transparencies designed for laser printers.
• Use rear paper exit to avoid curling.
Setting up to Print a Transparency
1. In your software program:
a. Enter the printer setup menu.
b. Select Manual Feed.
c. Select the transparency size.
2. Lower the rear paper exit tray and pull out the rear exit extender.
3. Lower the Front Feeder.
4. Flip out the tray, then pivot out the extender.
5. Adjust the paper width guides.
6. Insert the transparency with the side to be printed facing up.
7. Send the print command from your software.
8. When prompted to, press the FORM FEED button on the printer control
panel.
The printed transparency will exit at the rear.