ALFA OKIPAGE 20 - Manual (Page 39)

Chapter 4: The Front Feeder E–31
Manual Feed: Labels
Important! Sheet and label adhesive must withstand the fusing process
heat of 392°F (200°C) for 1 second.
Label adhesive must not be exposed; if it is, it will cause
jamming in the printer.
• Labels must cover the entire carrier sheet.
• Use rear paper exit to avoid peeling.
Setting up to Print Labels
1. In your software program:
a. Enter the printer setup menu.
b. Select Manual Feed.
c. Select the label sheet size.
2. Lower the rear paper exit tray and pull out the rear exit extender.
3. Lower the Front Feeder.
4. Flip out the tray, then pivot out the extender.
5. Adjust the paper width guides.
6. Insert the label sheet face up.
7. Send the print command from your software.
8. When prompted to, press the FORM FEED button on the printer control
panel.
The printed label sheet will exit at the rear.