Section 8: cleaning, Safety messages (review carefully) – HID DTC1000/4000 User Guide User Manual

Page 101

Advertising
background image

© 2012 HID Global Corporation

All rights reserved

DTC1000/DTC1000M/DTC4000 Card Printer/Encoder User Guide (L001398, Revision 1.5)

101

Section 8: Cleaning

The Card Printer is built to require a minimum amount of maintenance. Nevertheless, there are a few
procedures you can perform on a regular basis or as needed to ensure the best possible performance

Safety Messages (review carefully)

Symbol

Critical Instructions for Safety purposes

Danger:

Failure to follow these installation guidelines can result in
death or serious injury.

Information that raises potential safety issues is indicated by a
warning symbol (as shown to the left).

To prevent personal injury, refer to the following safety

messages before performing an operation preceded by this
symbol.

To prevent personal injury, always remove the power

cord prior to performing repair procedures, unless otherwise
specified.

To prevent personal injury, make sure only qualified
personnel perform these procedures.

Caution:

This device is electrostatically sensitive. It may be
damaged if exposed to static electricity discharges.

Information that raises potential electrostatic safety issues is
indicated by a warning symbol (as shown to the left).

To prevent equipment or media damage, refer to the

following safety messages before performing an operation
preceded by this symbol.

To prevent equipment or media damage, observe all

established Electrostatic Discharge (ESD) procedures while
handling cables in or near the Circuit Board and Printhead
Assemblies.

To prevent equipment or media damage, always wear an

appropriate personal grounding device (e.g., a high quality
wrist strap grounded to avoid potential damage).

To prevent equipment or media damage, always remove

the Ribbon and Cards from the Printer before making any
repairs, unless otherwise specified.

To prevent equipment or media damage, take jewelry off
of fingers and hands, as well as thoroughly clean hands to
remove oil and debris before working on the Printer.

Advertising