Avaya CPSEE_TSP500 - Manual (Page 121)

Chapter 6 Trunk Spans and Dialing Rules
CPSEE_TSP500 User Guide Version 4.0 Page 6-7
This document is confidential and proprietary to SER Solutions and is not for external use.
AUTO_LOG
If non-zero, it instructs the TSP to automatically log events. The value is the
decimal equivalent of the hexadecimal value of the bug setting. A typical set-
ting would be
AUTO_LOG 319
:
CALLING_NUMBER
This keyword defines a global originating number to be sent as Caller ID
information over ISDN lines. The TSP allows originating information to be
sent on a dial-by-dial basis, campaign basis, and a globally-assigned basis.
The precedence is:
1. Number by Number
2. Campaign Assigned
3. Global Assignment
The number assigned by this keyword can be overwritten by the Call Man-
ager or Gateway (and usually is).
CLOCK_MASTER
This keyword specifies the span to be designated the Primary Clock.
CLOCK_POLL
This keyword specifies (in seconds) the time to wait between processing
clocking information. The default is five seconds, which should not be
changed unless advised to do so by Engineering.
CONN_THREAD
This keyword is reserved for Engineering and should NEVER be modified
unless instructed to do so by Engineering. The default value for this keyword
is zero.
COUNTRY
Caution!
This equates to “bug 13f”
With this flag turned on, cer-
tain Admin_Terminal com-
mands may appear not to
work. However, it is possible
that the output (that would
normally go to the screen)
may be going to the log files.
You can turn logging off via
the “log” command. You may
first want to type “bug 0” to
prevent all the BUG mes-
sages from flooding the
screen.
Note:
Caller ID Text can only be
assigned by CPS Enterprise
Edition. There is no keyword
that assigns a default.