ATEN ATEN Matrix KVM KM0832 - Manual (Page 19)

Chapter 1. Introduction
9
KM0832 Rear View
1. Power Socket
The power cord to the AC source plugs in here.
2. POWER Switch
This is a standard rocker switch that powers the KVM switch on and off.
3. CONFIGURATION Port
The KM0832 is connected to the local network via the
CONFIGURATION port. It provides access to the KM0832 Administrator
Utility to configure the KVM installation, create and manage user and
group accounts, set device access permissions, upgrade firmware, etc.
4. F/W UPGRADE Switch
During normal operation and while performing a firmware upgrade, the
firmware upgrade recovery switch should be in the NORMAL position.
See p. 89 for firmware upgrade recovery details.
5. CHAIN OUT Port
When daisy chaining KVM switches (see p. 30), the CHAIN OUT port is
used to connect the lower-level KVM switches in the chain.
Note: If this feature is not operative on your unit, you will need a newer
version of the firmware. Contact your dealer for details.
1
6
7
2 3 4
5