Sony PCM-R300 - Manual (Page 17)

17 EN
Writing Sub Codes
3 Press 0 (REW) or ) (FF) to move the
beginning of the repeated portion.
Each time you press the
0 (REW) or ) (FF)
button, the beginning of the repeated portion shifts
backwards or forwards in 0.3-second increments,
up to a maximum extent of about 2 seconds (4
seconds in long-play mode) in either direction.
When writing a start ID
.
When writing a skip ID or an end ID
.
The time in the display shows the shift in position
from the time the ID REHEARSAL button was
pressed.
Example: Positioning Start ID
After pressing ) (FF) twice
0 6 . S
START ID
After pressing 0 (REW) twice
0 6 . S
START ID
4 Press WRITE to write the ID.
“(WRITE)” appears in the display while the deck
rewinds to the point where you pressed the button,
and then “ID WRITE” appears for a few seconds
and the ID is written on the tape at the selected
position.
• Start IDs are 9 seconds long starting from the
beginning of the repeated portion.
• Skip IDs are 1 second long starting from the end
of the repeated portion.
• An end ID is 9 seconds long starting from the
end of the repeated portion.
Newly written IDs positioned by the Rehearsal
function
,,
Adjusting the Position of an
Existing Start ID
You can adjust the position of previously recorded
start IDs.
ID MODE ID REHEARSAL
MARGIN
OPEN/CLOSE
RESET
RESET MODE
ENTER MENU
REW FF
SELECT DATA
AMS INPUT
ID
PHONES SBM ID MODE REC MODE
REC REC MUTING PAUSE PLAY STOP
PHONE LEVEL
REC LEVEL
RENUMBER REHEARSAL AUTO
WRITE ERASE
g
6
5 4 6
0
3 7
2 8
1 9
10
MAX MIN
ON 48 kHz 44.1kHz LONG
START STOP END
STANDARD
OFF
ANALOG OPT
POWER
COAXIAL
=
p P R r ”
+ 0 ) CH-1 (L) CH-2 (R)
1
Set ID MODE to START.
2
During playback, press ID REHEARSAL when the
existing start ID you want to reposition is
displayed.
The deck rewinds to the beginning of start ID and
Rehearsal repeats a 3-second portion.
3
Do steps 3 and 4 of “Accurate positioning of sub
codes (Rehearsal function)” on this page.
You can move the start ID to a maximum extent of
about 2 seconds (4 seconds in long-play mode) in
either direction from its original position.
Notes
• Start IDs written within 10 seconds from the end of the
tape may be difficult or impossible to move.
• Existing skip IDs or an end ID cannot be moved.
0.3 sec
Position where the ID REHEARSAL
button is pressed in step 2.
Movement with
each press of
0 (REW)
Repeated portion
3 seconds
0.3 sec
Movement with
each press
of
) (FF)
Repeated portion
3 seconds
Position where the ID REHEARSAL
button is pressed in step 2.
Movement with
each press of
0 (REW)
Movement with
each press
of
) (FF)
0.3 sec
0.3 sec
Repeated portion
Start ID 9 seconds
Skip ID 1 second
n Tape direction
End ID 9 seconds