Sony PCM-R300 - Manual (Page 20)

Menu Operations
20 EN
SKIPPLAY (SKIP PLAY)
Selects if the deck detects skip IDs and fast-forwards
the tape to the next start ID during playback.
Settings: on (the deck detects skip IDs),
-- (the deck does not detect skip IDs)
Factory setting: --
Reference page: 14
Automatic writing of start IDs and menu settings
during digital recording
The automatic detection and writing of start IDs are
carried out according to the jack to which the program
source is connected, the signal format, and the category
code of the signal, as shown in the table below.
A: Start IDs are detected and written automatically.
B: Q codes are detected and written as start IDs
automatically.
C: The writing of start IDs is determined by the settings
of the L-SY TH and L-SY BK menus.
TAPEID6 (ID6 on TAPE)
Displays the copy information of the tape currently
inserted.
Indications: 00 (copying permitted), 10 (copying
prohibited), 11 (one generation copy
only)
Reference page: 5
DIF (Digital Input signal Format)
Shows the format of the digital input signal from the
connecter selected by the INPUT switch. Use this
menu while the deck is in recording pause or while
you are monitoring the program source.
Displays: -- -- (the INPUT switch is set to
“ANALOG” or no digital signal is
input),
NON AU (non-audio-format signal is
input; not recordable on this deck),
PRO (signal for broadcast studio use is
input),
DAT (signal is input from a DAT deck
for consumer use),
CD (signal is input from a CD player for
consumer use),
MD (signal is input from a MD deck for
consumer use),
GEN (signal is input from a BS tuner
etc.),
OTHER (signal is input from other
components than described above)
Reference page: 6
HOUR (HOURs meter)
Displays the total drum operating time for periodic
check-up.
Display range: 0 to 9999 hours (in units of 1 hour)
INIT SET (INITial SETting)
Resets all the menu settings to factory settings.
Settings: on (resets the menu settings),
-- (does not reset the menu settings)
Factory setting: --
* Only when connected to the PCM-2300, PCM-2700, or
PCM-2700A
P-TMDISP (Program TiMe DISPlay)
Specifies if the track playing time is displayed when
the MODE button is pressed.
Settings: on (the track playing time is displayed),
-- (the track playing time is not
displayed)
Factory setting: on
Reference page: 12
FIRST(PGM NO.) (FIRST ProGraM NO.)
Specifies the first program number to be assigned to
the first track when recording from the beginning of
the tape or using the Renumbering function.
Setting range: 1 to 99
Factory setting: 1
Reference pages: 16, 18
Menu settings
Category
Signal
format
Jack
Others
COAXIAL/OPTICAL
Consumer use
CD DAT
Broadcast studio
use
COAXIAL
—
IEC S-ID on A* A — C
IEC-S-ID -- C C — C
IEC CD-Q on — — B C
IEC CD-Q -- — — C C