Sony PCM-R300 - Manual (Page 4)

4 EN
Getting Started Getting Started
Unpacking
Check that you have received the following supplied
items:
• AC power cord (1)
• Remote commander (remote) RM-D757 (1)
• Size-AA (R6) batteries (2)
• Rack mount adaptors (2)
• Screws (M5
×
12) (4)
• Decorative washers (4)
• Decorative panel (1)
• Tapping screws (3
×
8) (2)
• Operating instructions (1)
Inserting batteries into the remote
Insert two size-AA (R6) batteries, matching the + and –
on the batteries with the markings inside the battery
compartment.
z
When to replace the batteries
With normal use, batteries should last for about 6
months. When the remote no longer operates the deck,
replace both batteries.
Notes
• Do not leave the remote near an extremely hot or humid
place.
• Do not drop any foreign matter into the remote casing,
particularly when replacing the batteries.
• Do not expose the remote sensor to direct sunlight or
illumination as doing so may cause malfunction.
• When not using the remote for an extended period of time,
remove the batteries to avoid possible damage from
battery leakage and corrosion.
Rack Mounting
You can use the supplied rack mount adaptor to install
your deck in a 19-inch 3U-size rack. Be sure to turn the
deck off before you install it.
1
Remove the screws (M3
×
10) from the sides of the
deck.
2
Position the rack mount adaptors onto the sides of
the deck as shown below and secure them with
the screws removed in step 1.
3
If necessary, attach the decorative panel with the
tapping screws (3
×
8).
The decorative panel covers the space that forms
below the deck.
4
Insert the deck into the rack and secure it with the
supplied decorative washers and screws (M5
×
12).
Rack mount adaptor
Screw (M3 × 10)
Tapping screw (3
×
8)
Screw (M5 × 12)
Decorative washer
Screw (M3 × 10)
Rack