AEG COMPACT READER ARE I2 - Manual (Page 18)

Manual
Page 18 / 33- Revision 01
ARE I2 / RS 232 – Installation Guide
AEG
Identifikationssysteme GmbH
Söflinger Straße 100
D-89077 Ulm
Tel. ++49(0)731-933-1340/1877
Fax ++49(0)731-933-1855
e-mail: [email protected]
0 one out of one (no effect)
1 two out of two ; (default value)
Output (example): 1 <CR>
Sequence of readings Length of the reading cycle Result of the reading cycle
NoRead 1 reading NoRead
0000125ED1, 0000125ED1 2 readings 0000125ED1
0000125ED1, 0000126ED1 2 readings NoRead
Schedule 6-: example for a reading cycle with NID=1
Example: A, B, C are specific different transponder numbers, N is NoRead:
Sequence of reading cycles Output sequence after
filtering with CN=0 and
CID=1
Output sequence after
filtering with CN=1 and
CID=1
N, N, ......,N, A, A, A, ....A, N,N, ......... N, N, ......,N, A, N, N,
.......
A
N. N, N, A, A, A, N, A, A, B, A, C, C, C, ....... N. N, N, A, N, B, A, C,
.....
A, B, A, C
N, N, B, B, B, B, B, N, N, N, B, B, B, B, N,
N,...
N, N, B, N, N, N, N, N,... B
N, N, N, B, B, B, B, B, N, B, B, B, B, N, N, N,
....
N, N, N, B, N, N, N, N,
....
B
Table 6-: example for the effect of the CID function
Annotation: The internal reference number is deleted in the following conditions:
• after a cold start
• after a warm start
• after entering the command line CID <SP> 1 <CR>
This causes that the next transponder code is output definitely.
Caution: The filter function CID picks up the results of the complete reading
cycles, while the parameter NID proceeds from the results of single
readings! The filter function CID has effect on the serial interface
only.