AEG COMPACT READER ARE I2 - Manual (Page 26)

Manual
Page 26 / 33- Revision 01
ARE I2 / RS 232 – Installation Guide
AEG
Identifikationssysteme GmbH
Söflinger Straße 100
D-89077 Ulm
Tel. ++49(0)731-933-1340/1877
Fax ++49(0)731-933-1855
e-mail: [email protected]
7.2 Operating Mode 0 - Continuous Reading
When operating continuously the exciter is switched on permanently. The reading cycles
are initiated periodically.
After an accomplished reading cycle the reading information is evaluated. After that data (ei-
ther transponder number or NoRead code) is output to the serial interface
Figure 7.2: continuous operation
7.2.1 Settings of the Reader / Most Used Parameters
The default operation mode is changed by sending a software command to the reader.
In combination with an R / W transponder, the serial number of the transponder device is read
out only.
MD 0 - continuos read
most used parameters.
• CID 0 - no suppression of repeatedly read Ids
• CN 0 - no suppression of NoReads
exciter
processor
interface
reading cycle
ID ID ID
reading cycle reading cycle