ATTO Technology Diamond Storage Array VT-Class - Manual (Page 43)

32
Diamond Storage Array Installation and Operation Manual
6.2 General Use Commands
The following commands, listed alphabetically, describe or perform general functions.
FirmwareRestart
Causes a warm restart of the Diamond Storage Array.
Immediate: FirmwareRestart
Help
Displays a list of available commands. Type ‘help’
followed by a command name to display detailed
command-specific information.
Immediate: Help [Command Name]
RestoreConfiguration
Restores configuration to either the default configuration
or the configuration last saved into non-volatile memory.
The saved option will undo any changes made since the
last save.
Immediate: RestoreConfiguration [Default|Saved]
SaveConfiguration
If the restart option is selected, the Diamond will cycle its
power. The norestart option will save changes without
restarting. Please note: certain modifications require a
SaveConfiguration command and a system restart. If
required, the return Ready. * will be displayed after the
return for the modification. You may make several
changes through commands and
SaveConfiguration
before implementing a restart, but once you have
restarted the Diamond, all the command changes created
before the restart and saved will be implemented. Restart
or no Restart parameter is optional
Immediate: SaveConfiguration <Restart| NoRestart>
SystemSN
Stores the Diamond Storage Array serial number. The
serial number may be 1-16 characters.
Set syntax: set SystemSN [n]
Requires a SaveConfiguration command
Get syntax: get SystemSN
VerboseMode
Specifies the detail of verbal feedback for the Command
Line Interface. Disabling this option removes parameter
names from ‘get’ commands and removes descriptions
from ‘help’ commands.
Default: enabled (returns have parameter information)
Set syntax: set VerboseMode [enabled | disabled]
Get syntax: get VerboseMode
ZoneCommit
Commits the current Planned Zone Configuration,
making it the persistent, Active configuration. To
complete this procedure, the ZoneState command must be
entered as enabled to activate the zone before using the
ZoneCommit command.
Set syntax: ZoneCommit