ATTO Technology Diamond Storage Array VT-Class - Manual (Page 53)

42
CLI: configure drives
DriveWipe
Initializes a drive: wipes it of all data. Drive must be
offline
Set syntax: DriveWipe [Destination Sled] [Dest Drive]
Requires a SaveConfiguration Restart command
Get syntax: DriveCopyStatus
ECC
Specifies or displays whether ECC is enabled or not. If
ECC is not available, an
ECC invalid message will be
returned.
Default: enabled
Set syntax: set ECC [enabled | disabled]
If enabled, SaveConfiguration Restart command required
If disabled, SaveConfiguration command required
Get syntax: get ECC
IdeTransferRate
Sets the DMA mode transfer rate for all devices. Choices
are 0, 1, 2, 3, 4
Default: 4
Set syntax: set IdeTransferRate [0 | 1 | 2 | 3 | 4]
Requires a SaveConfiguration Restart command
Get syntax: get IdeTransferRate
IdeWriteCache
Sets write caching for all drives.
Default: enabled
Set syntax: set IdeWriteCache [enabled |disabled]
Requires a SaveConfiguration Restart command
Get syntax: get IdeWriteCache
InquiryData
Sets/displays the SCSI media changer (MC) & tape drive
(TD) inquiry data returned by the Diamond Virtual Tape
device.
MC Vendor ID: 1 - 8 chars
MC Product ID: 1 - 16 chars
MC Revision: 1 - 4 chars
TD Vendor ID: 1 - 8 chars
TD Product ID: 1 - 16 chars
TD Revision: 1 - 4 chars
Set syntax: set InquiryData [MC Vendor ID] [MC Product
ID] [MC Revision] [TD Vendor ID] [TD Product ID] [TD
Revision]
Requires a SaveConfiguration Restart command
Get syntax: get InquiryData
LUNInfo
Displays information about all LUNs (logical unit
numbers) or detailed information about a specific LUN.
Do not specify a LUN to get information about all LUNs.
Specify a LUN to get detailed information about that
individual LUN. For examples, see LUNInfo on page
39.
...
Get syntax: get LUNInfo [LUN]
LUNState
Sets the LUN to the specified state. May be used to
facilitate removal and insertion of sleds and RAID groups
during power up/power down of sleds.
Default: online
Set syntax: set LUNState [LUN number] [online|offline]
Get syntax: get LUNState [LUN number]
MediumType
Sets or displays the medium type returned by the mode
pages. Use the command
InquiryData to change the
inquiry data displayed. Choices are
DLT/Diamond = 0x85
SDLT = 0x86
LTO = 0x00
AIT = 0x34
Default: 0x85
Set syntax: set MediumType [medium type]
Requires a SaveConfiguration Restart command
Get syntax: get MediumType
PartitionInfo
Displays Partition information for the selected partitions.
See PartitionInfo on page 39 for examples.
Immediate command: PartitionInfo [active|planned]
[Virtual Drive ID] [Partition ID]
QuickTape
Configures the Diamond-VT as a Virtual Tape device.
Specify the RAID level, either RAID5 or RAID10, the
number of tape volumes, enable ZoneState and specify
whether Hot Spare sleds are enabled.
The system will determine the optimal number of Virtual
Devices based on the number of tape volumes. Hot Spares
are not available for all Virtual Tape configurations. You
must designate enabled to allow Hot Spare sleds or
disabled to forgo Hot Spare sleds
You may specify the first four to six alpha-numeric
characters of a tape bar code, used by tape backup