ATTO Technology Diamond Storage Array VT-Class - Manual (Page 45)

34
Diamond Storage Array Installation and Operation Manual
SNMPTraps
Enables or disables SNMP traps.
Default: disabled
Set syntax: set SNMPTraps [enabled|disabled]
Requires a SaveConfiguration Restart command
Get syntax: get SNMPTraps
SNMPUpdates
Enables or disables the SNMP Management Information
Base (MIB) database.
Default: disabled
Set syntax: set SNMPTraps [enabled|disabled]
Requires a SaveConfiguration Restart command
Get syntax: get SNMPUpdates
TelnetPassword
Specifies password for telnet session. Only one
username/password combination is available per
Diamond Storage Array. RestoreConfiguration default
sets the telnet username and password to the default
values.Password is case insensitive, 1 to 8 characters.
Default: diamond
Set syntax: set TelnetPassword [password]
Get syntax: none
Requires a SaveConfiguration command
TelnetTimeout
Specifies the number of minutes of inactivity which will
elapse before a telnet session automatically times
out.Limits: 1-1440 minutes.
Default: disabled
Set syntax: set TelnetTimeout [1-1440 | disabled]
Get syntax: get TelnetTimout
Requires a SaveConfiguration command
TelnetUsername
Specifies username for telnet session. Only one
username/password combination is available per
Diamond Storage Array. RestoreConfiguration default
sets the telnet username and password to the default
values.Username is case insensitive, 1 to 8 characters
Default: telnet
Set syntax: set TelnetUsername [username]
Requires a SaveConfiguration Restart command
The Telnet and SNMP protocols also use CLI
commands.
TelnetUsername
Specifies username for telnet session. Only one
username/password combination is available per
Diamond Storage Array. RestoreConfiguration default
sets the telnet username and password to the default
values.Username is case insensitive, 1 to 8 characters.
Default: telnet
Set syntax: set TelnetUsername [username]
Get syntax: none
Requires a SaveConfiguration command