Muxlab HDMI 4x4 Matrix Switch - Manual (Page 12)

© MuxLab Inc. HDMI 4x4 Matrix Switch Installation Guide
Page 12
3.5. Installation Procedure
In order to install the product, please follow the steps
below:
1. Place the HDMI 4x4 Matrix Switch in its final
location.
2. Ensure that the power is turned off on the HDMI
source and displays.
3. In order to distribute the HDMI, one (1) HDMI
Receiver (500407 or 500417) must be connected at
each HDMI display. To install the Receivers,
complete Steps 4, 5, and 6.
4. Identify the pin configuration of the Receivers. Two
(2) Cat 5e/6 UTP/STP cables are required for each
HDMI connection. The pin configuration follows the
EIA/TIA 568A/B standard. The HDMI Receiver is
reverse-polarity sensitive. Please ensure that the
wiring is straight-through (Ring to Ring, Tip to Tip),
and that the two HDMI twisted pair links are not
crossed.
5. Using an HDMI cable (not supplied), plug each
HDMI source to an HDMI input of the Matrix
Switch.
6. Using an HDMI cable (not supplied), connect an
HDMI Receiver (500407 or 500417) to each HDMI
display.
7. Complete the connection between the Matrix Switch
and each HDMI display using standard straight-thru