Muxlab HDMI 4x4 Matrix Switch - Manual (Page 13)

© MuxLab Inc. HDMI 4x4 Matrix Switch Installation Guide
Page 13
Cat 5e/6 UTP/STP cables and connecting hardware,
terminated on RJ45 plugs at both ends. Ensure that
there are no split pairs or taps.
8. Optional: Local televisions may be connected using
HDMI cables (not supplied).
9. Power up the Receivers and HDMI equipment first.
10. Connect the external 12VDC power supply to the
Matrix Switch and plug the power supply into an AC
power outlet. If power is present, the blue power
LED will be ON.
11. Ensure that the source and appropriate display LEDs
are ON. Images should appear on the displays within
10 seconds. Check the image quality and refer to the
troubleshooting table in Section 4 if image quality is
unsatisfactory.
12. Figures 4 and 5 show some typical configurations:
Figure 4: Typical Configuration (I)