Muxlab HDMI 4x4 Matrix Switch - Manual (Page 14)

© MuxLab Inc. HDMI 4x4 Matrix Switch Installation Guide
Page 14
Figure 5: Typical Configuration (II)
Please note that Figure 5 is for users who do not require
control of the Matrix Switch from a remote location. In
such a case, MuxLab’s HDMI Receiver (500407) may
be used.
The IR Emitters included with the Matrix Switch are
used to control HDMI sources. Simply insert the plug of
an IR Emitter into any one of the 4 “IR Emitter” jacks
located on the back panel of the Matrix Switch. The
number of the jack (1, 2, 3, or 4) into which a specific
Emitter is plugged determines which HDMI Source that
Emitter will control. For example, an IR Emitter
plugged into IR Emitter jack 3 will control HDMI
Source 3.
For more information on installing and using IR
Emitters, please refer to MuxLab’s IR Emitter Quick
Installation Guide.