Muxlab HDMI 4x4 Matrix Switch - Manual (Page 21)

© MuxLab Inc. HDMI 4x4 Matrix Switch Installation Guide
Page 21
Once all hardware has been connected, the user must
perform the following three steps:
1. Load the Matrix Switch (automatically or manually)
2. Configure the Matrix Switch
3. Control the Matrix Switch
1. Loading the Matrix Switch
Loading consists of detecting the Matrix Switch (or any
other software-controllable MuxLab device) connected
to a PC. Loading can be done either automatically or
manually. If done automatically, every device is loaded
simultaneous by the software. If done manually, each
device must be individually loaded by the user.
Once the Matrix Switch has been successfully loaded, it
will be displayed in the Devices tree.
To load a device automatically, select Devices>Load
All Connected Devices… (Figure 13).
Figure 13: Loading All Connected Devices