Muxlab HDMI 4x4 Matrix Switch - Manual (Page 25)

© MuxLab Inc. HDMI 4x4 Matrix Switch Installation Guide
Page 25
3.9. Ethernet Web Interface
MuxLab offers users an Ethernet Web interface that
provides the same functionality as our Control Center
Software, with speeds between 10 Mbps and 100 Mbps.
For the Ethernet Web interface to function, the Matrix
Switch must first be physically connected to an Ethernet
network. To do this, locate the RJ45 Ethernet jack on
the back panel of the Matrix Switch, then connect it to
an Ethernet network using a straight UTP cable (max.
length 333 ft [100 m]). There are two LEDs at the top of
the RJ45 Ethernet jack: A yellow LED will go on if a
link is detected, and a green LED will blink if Ethernet
activity is detected.
Once the Matrix Switch has been physically connected
to an Ethernet network, go to
http://AAA.BBB.CCC.DDD
(where AAA.BBB.CCC.DDD is the IP address assigned
to the device).
The home screen presents users with the option of using
a password (Figure 18).
Figure 18: Web Interface Home Screen