Muxlab HDMI 4x4 Matrix Switch - Manual (Page 16)

© MuxLab Inc. HDMI 4x4 Matrix Switch Installation Guide
Page 16
Manual Control
The HDMI 4x4 Matrix Switch may be controlled
manually by using the push buttons located on its front
panel. Each “Display” push button controls the
particular display corresponding to its number (1, 2, 3,
or 4). By pressing on a given Display push button, the
user can choose which HDMI Source to send to that
display. The number of the HDMI Source being sent to
a particular display at any given time is indicated by an
illuminated LED next to the “Source” number (1, 2, 3,
or 4).
IR Remote Control
The Remote Control (shown on right) is divided into 4
sections, with each section controlling a particular
display. For any given display, the user
can choose which HDMI Source to send
to that display, either directly by
clicking on push buttons 1, 2, 3, or 4, or
indirectly by pressing on the left & right
arrow push buttons to cycle through
HDMI Sources. Note that when the
Remote Control is used in conjunction
with MuxLab’s HDMI Receiver
(500417), the user will only be able to
control the display which is connected
to the local HDMI Receiver.