Apple Color LaserWriter 12/600 PS - Manual (Page 15)

The Color LaserWriter 12/660 PS printer uses the same setup procedures as
for the Color LaserWriter 12/600 printer with a few exceptions. This chapter
describes those exceptions. To set up the printer, read this chapter first, then
read Chapter 1 of the Color LaserWriter 12/600 PS User’s Manual.
Choosing a place for the printer
When setting up the printer, be sure to follow these guidelines or your printer
may not operate properly:
m Choose a flat, stable area with adequate room to give you access to all
sides of the printer. The printer weighs approximately 110 pounds
(approximately 50 kilograms). Make sure you place it on a desk or table
that’s strong enough to hold the weight.
m Don’t lift the printer by yourself. Have at least one other person assist you.
m The area should be well ventilated and away from direct sunlight or
sources of heat, cold, or humidity. Abrupt changes in temperature and
extremely high or low humidity can adversely affect print quality.
m Unpack the printer in the location where the printer will be set up. Since
the printer contains a fuser oil reservoir, it is important not to install the
fuser oil bottle until the printer is located where it will be used.
1
1
Setting Up the Color LaserWriter 12/660 PS