Apple Color LaserWriter 12/600 PS - Manual (Page 24)

Before you begin
This chapter presents instructions for installing the Mac OS printer software
and configuring the printer with it. Before you begin, make sure you have
m set up the printer as described in Chapter 1 of this update and Chapter 1 of
the Color LaserWriter 12/600 PS User’s Manual
m connected the printer to your network
m made backup copies of the printer disks (if your printer software was
shipped on a CD-ROM disc, you can skip this step)
Be sure to complete these tasks before continuing with the procedures in
this chapter.
System requirements
To use the printer software, your Mac OS–based computer must have system
software version 7.1 or later and at least 4 megabytes (MB) of memory (8 MB
recommended). If your system software is an earlier version, you need to
obtain a system software upgrade from your computer or software dealer.
Installing all the printer software and fonts requires approximately 9 MB of
free space on your hard disk.
Initial AppleTalk setup
The printer comes with software and fonts for use with Mac OS–based
computers. Before Mac OS users can print, the printer administrator must
connect the printer to the network, install the printer software and fonts, and
configure the printer.
Chapter 2 10