ATTO Technology Diamond Storage Array S-Class - Manual (Page 44)

33
ATTO Technology Inc. Diamond Storage Array Installation and Operation Manual
5.5.2 General Use Commands
The following commands, listed alphabetically, describe or perform general functions.
FirmwareRestart
Causes a warm restart of the Diamond Storage Array.
Immediate: FirmwareRestart
Help
Displays a list of available commands. Type help
followed by a command name to display detailed
command-specific information.
Immediate: Help [Command Name]
RestoreConfiguration
Restores configuration to either the default configuration
or the configuration last saved into non-volatile memory.
The saved option will undo any changes made since the
last save.
Immediate: RestoreConfiguration [Default|Saved]
SaveConfiguration
If the restart option is selected, the Diamond will cycle its
power. The norestart option will save changes without
restarting. Please note: certain modifications require a
SaveConfiguration command and a system restart. If
required, the return Ready. * will be displayed after the
return for the modification. You may make several
changes through commands and SaveConfiguration
before implementing a restart, but once you have
restarted the Diamond, all the command changes created
before the restart and saved will be implemented. Restart
or no Restart parameter is optional
Immediate: SaveConfiguration <Restart| NoRestart>
SystemSN
Stores the Diamond Storage Array serial number. The
serial number may be one to 16 characters.
Set syntax: set SystemSN [n]
Get syntax: get SystemSN
Requires a SaveConfiguration command
VerboseMode
Specifies the detail of verbal feedback for the Command
Line Interface. Disabling this option removes parameter
names from ‘get’ commands and removes descriptions
from ‘help’ commands.
Default: enabled (returns have parameter information)
Set syntax: set VerboseMode [enabled | disabled]
Get syntax: get VerboseMode