Chapter 6: advanced setting, System, Status – Allied Telesis AT-WR2304N User Manual
Page 33: Figure 34: system > status, Figure 35: system lan
AT-WR2304N IEEE 802.11 b/g/n, Small Business Wireless Router User Manual
23
Chapter 6: Advanced Setting
System
This page shows system status, LAN settings, DHCP, log and statistics. Please access by clicking on “System”
on the left side.
Status
This page displays information about firmware version, WAN/LAN/WLAN settings.
Figure 34: System > Status
LAN
In this page, you can perform LAN settings, such as virtual IP, subnet mask, DHCP server, etc.
Figure 35: System LAN
)
IP address: LAN IP of this equipment. Do not change it unless special need.
)
IP Subnet Mask: The default value is “255.255.255.0”.
)
802.1d Spanning Tree: Spanning Tree Protocol (STP) is a standard mechanism to maintain
network bridge and switch. When conflict occurs, it coordinates network bridges and switches.
The default value is “Disabled”.
)
DHCP Server: When “Enabled” is selected, the equipment sends IP address as a DHCP server.
When “Disabled” is selected, you have to manually assign IP and subnet mask. The default value is
“Enabled”.