Allied Telesis AT-WR2304N - Manual (Page 49)

AT-WR2304N IEEE 802.11 b/g/n, Small Business Wireless Router User Manual 39
) WPS Current Status: The message “configured” means wireless encryption is property set.
Disable encryption function by clicking on “Release Configuration”.
) Self Pin Code: This is the WPS PIN code of AP. You can input this PIN code to wireless adapter.
Refer to <Input PIN Code to Wireless Adapter>for the detail configuration.
) SSID: This is the SSID of AT-WR2304N IEEE 802.11 b/g/n, Small Business Wireless Router.
) Authentication Mode: It shows the current authentication mode information.
) Passphrase Key: It shows the authentication key of AT-WR2304N IEEE 802.11 b/g/n, Small
Business Wireless Router. If the wireless adapter does not support WPS, you will need it to
connect to this wireless router.
) WPS Via Push Button: Click on “Start to Process” to perform WPS PBC setting. Refer to
<Push Button Connection > for the detail configuration.
) WPS Via PIN: Input wireless adapter PIN code and click on “Start to Process” to perform WPS.
Refer to <Input PIN Code to Wireless AP> for the detail configuration.
Client List
This page shows wireless LAN client information. You can reload the page by clicking on “Refresh”.
Figure 67: Wireless > Client List
Interface: It shows the SSID that client is connecting to.
MAC Address: It shows the client’s MAC address.
Signal (%): It shows the signal quality.
Idle Time: It shows the idle time of the client.
Policy
In this page, you can manage the equipment’s wireless networking policy. AT-WR2304N IEEE 802.11 b/g/n,
Small Business Wireless Router gives flexibility to configure each SSID for your need.
Figure 68: Wireless > Policy
) WAN Connection: When this function is enabled, users who connect to this SSID are allowed
to connect to WAN. When this function is disabled, users cannot visit WAN resource.
) Communication between Wireless Clients: When this function is disabled, users cannot
connect to other wireless users, but are allowed to connect to LAN users.
) Communication between Wireless Clients and Wired Clients: When this function is
disabled, users cannot connect to LAN users, but are allowed to connect to other wireless users.
Firewall
This page provides setting such as port filter, IP filter, port forwarding, DMZ, DoS and VPN. Please access by
clicking on “Firewall” on the top-left side.