AMX UDM-0404 - Manual (Page 36)

Configuration - Status Page
24 UDM-0404 4x4 Multi-Format Distribution Hub
Port Configuration Options
Click on any of the Port (1-4) links on the Status page (see FIG. 15) to access the Port Configuration
options for the selected Port (FIG. 16):
The Port Configuration Options include:
FIG. 16 Port Configuration Options
Port number and Click to access
Control options
for this port
Click to send current settings
to the Receiver
Click to return all Port Configuration options to default settings
firmware version
The video compensation options shown in FIG. 16 are only presented when a
Receiver is connected to the selected port.
Port Configuration Options
Port Number and
Firmware version: Displays the currently selected Port (1-4), and the current firmware version.
User Control: Click to access the User Control options for this Port, to allow Administrators to issue
commands from the UDM WebConsole. See the User Control section on page 30 for
details.
Send Settings To RX: Click to send the current settings to the UDM Receiver connected to this Port.
Default: Click to return all Port Configuration options for this Port to their default settings.
Remote Type: Click to select the type of remote controller to be used for Passthrough control for
this Port (if applicable). See the Passthrough Mode (Inputs A – D) section on
page 34 for details.
Port Name: The current name for this Port. Click and type in this text field to rename this Port.
See the Renaming Output Ports section on page 25 for details.
Bright Up/Down Once any skew has been eliminated the video should be adjusted for brightness
using a grey scale or equivalent test card.
Sharp Up/Down The sharpness of the video should be adjusted last, to eliminate any over or under
shoot of the video. Horizontal black and white bars are one useful method of tuning
sharpness.
Sync: Click to select a sync mode for this port. Options include: Common, Auto, On Green,
Negative and Positive). By default "Common" sync is selected - in most situations
the sync mode should not be changed unless there are sync issue with a particular
display device.