AMX UDM-0404 - Manual (Page 75)

Configuration - Protocols Page
63 UDM-0404 4x4 Multi-Format Distribution Hub
5. A message saying Press key on remote will appear (FIG. 94).
6. Click the key on the device’s remote control which will manage the action Power On.
7. Click on Step 2 to repeat the process for this command.
8. A message saying Press key on remote will appear. Click the key on the device’s remote control
which will manage the action Power On.
Updating the UDM Receiver With the IR Protocol
1. Ensure the Infrared Protocol has been created previously.
2. Click on the Status page.
3. Click on the port number hyperlink which the device is attached to. It is the Receiver which will
transmit the IR command to the devices IR interface.
4. Once the port properties become visible click on the arrow to the right of the Protocol field.
5. Select the IR protocol which this Receiver will download. This may take a few minutes depending
on how many commands are within the table.
6. A message will appear saying “Loading Protocol – Please wait” once this has disappeared the IR
protocol has been downloaded to the RX device. IR commands can now be sent from the Hub Web
pages to the device.
Testing Serial Control Commands
Device serial codes can be tested via options in the Status page, before they are added to the protocol
library.
The UDM-RX02 can store approximately eight serial commands per device, depending on the length of
the serial string.
1. On the Status page. click on a Port hyperlink to access the Port Configuration options.
2. In the Protocol drop-down menu, select Serial to enable the Serial-specific configuration options
shown in FIG. 95.
FIG. 94 Capturing IR Protocol - "Press key on remote"
The IR learning process requires that the command on the device’s remote is learned
twice (i.e the same remote control command needs to be repeated at Step 2).
A UDM-RX01/02 Receiver, which will issue the relevant IR commands to the device,
must be connected to the relevant port via a Cat5/e/6 cable. Remember the IR
commands are stored within the Receiver.
Serial commands are stored in the UDM-RX02, and care should be taken to keep any
serially programmed units associated with the correct display device type.