AMX UDM-0404 - Manual (Page 40)

Configuration - Status Page
28 UDM-0404 4x4 Multi-Format Distribution Hub
Video Compensation (UDM-RX01/RX02)
Video at the Receive end can be compensated using three main methods;
Using the WebConsole to compensate each port individually in the Status option (see the
Video Compensation section on page 25).
Using the Endeleo Remote Control to compensate video (see the Compensating Video Via the
UDM-RC10 Remote Control section on page 27).
Using a hyper terminal session via the serial connector on the UDM-RX02 (especially
effective when using long runs). See the Advanced Administration section on page 67 for
details.
Dual Output Mode
With the Enable advanced options checkbox selected in the Setup page (see FIG. 18 on page 26), the
Port Configuration options include the Dual Output checkbox (FIG. 20).
Dual Output mode permits a single input to be viewed as two separate output types. For example a port
could be configured for the dual output of VGA and Component video. This means at the UDM
Receiver, the input could be delivered to two separate display devices.
.
Selecting Inputs For Display
1. Each port on the hub has a drop down box, in which will be displayed all of the inputs (as
configured in the Inputs page) available to this particular Port (FIG. 22).
2. Select the appropriate Input (VGA display, DVD, TV Channel) which this port will display.
The compensation settings will be specific to this UDM-RX02 and stored internally
(for example, if this UDM-RX02 is replaced or swapped out the compensation
settings will travel with the UDM-RX02). It may therefore be necessary to re-
compensate the UDM-RX02 / replacement UDM-RX02 if this UDM-RX02 is to be
used elsewhere or is being replaced.
Ensure the correct cabling is in place at the RX to accommodate the 2 separate
signals.
FIG. 22 Inputs available for a Port
Inputs available to Port 1
"Inputs" mean inputs directly connected to the rear of the UDM-0404 (e.g. Inputs A-D,
or devices connected to IRTx ports 1 – 4.