AMX UDM-0404 - Manual (Page 86)

Advanced Administration
74 UDM-0404 4x4 Multi-Format Distribution Hub
Copying IR/Serial Tables
To copy the IR/Serial tables from a UDM-0404:
1. Run your TFTP client. If using the Windows client, move to step 2.
2. Create a folder on the C: drive named Endeleo.
3. Open a command prompt (Start, Run, type "cmd" <enter>) and change it to the C:\Endeleo
directory.
4. Connect the serial cable (RJ12 to DB9) that is supplied with the UDM-0404.
5. Open a Hyperterminal session and connect to the UDM-0404 (9600, 8, None,1, None)
6. Type the following command at the prompt:
TFTP -i <ip address of the UDM-0404> get ixxxx.hub <enter>
Example:
C:\Endeleo\TFTP -i 192.168.1.201 get iudm.hub <enter>
7. After hitting Enter, you should watch the Hyperterminal session window to see the file download
from the UDM-0404.
8. The transfer is now complete.
Endeleo UDM Receiver Commands
Several Receiver-specific commands can be used for information purposes.
Viewing Video Compensation Settings
The z command will report the current compensation settings configured within the UDM Receiver.
1. Use Hyperterminal to connect to the Receiver via its serial port.
2. At the command prompt type in setup.
3. Once in setup mode to view the compensation settings, type in z. (FIG. 104)
Windows XP Pro has a built in TFTP client program. If you are using another
operating system, or have an alternate TFTP client, follow the directions of your OS
and install TFTP client if necessary. Consult with AMX Technical Support as to the
appropriate client for your OS.
FIG. 102 GET iudm.hub prompt
FIG. 103 File download from the UDM-0404