Pioneer PDR-F10 - Manual (Page 29)

6 More Recording Features
29
English
En
Clearing skip IDs
1 Make sure that skip play is off.
See above for how to do this.
• If the SKIP ON indicator did not light
when you loaded the disc then there are
no skip IDs present on that disc.
2 Start playing the track you want
to clear the skip ID for.
3 Press SKIP ID.
The skip indicator blinks and the display
shows the track number (blinking) and
SKIP
CLR .
• If this track doesn't have a skip ID, the
player jumps to the next track that does
and starts playback of that track.
• Use the
4 and ¢ buttons to move
between tracks that have skip IDs set.
4 Press SKIP ID again to confirm.
5 Clear further skip IDs by repeat-
ing steps 2–4.
6 When you're finished, stop the
disc and press OPEN/CLOSE (CD-
R OPEN/CLOSE on the remote).
Until you eject the disc, the recorder stores the
changes in skip ID information in its
memory. On pressing
OPEN / CLOSE , the
recorder writes the new skip ID information
onto the disc.
Setting skip IDs
1 Press SKIP ID (top panel only)
during playback (or play-pause)
of the track you want to skip.
The SKIP indicator lights and the display
shows the track number and SKIP SET .
• If there's no room left on the disc to record
another skip ID, the display will show the
message
SKIP FULL .
2 Press SKIP ID again to confirm.
3 Set further skip IDs by repeating
steps 2 and 3.
4 When you're finished, stop the
disc and press OPEN/CLOSE
(CD-R OPEN/CLOSE on the
remote).
Until you eject the disc, the recorder stores the
skip ID information in its memory. On
pressing
OPEN / CLOSE , the recorder writes
the skip ID information onto the disc.