Pioneer AVIC-X1 - Manual (Page 112)

110
Appendix
NAVI/AV
Error Messages
When problems occur with disc playback, an error message appears on the display. Refer to the table
below to identify the problem, then take the suggested corrective action. If the error persists, contact
your dealer or your nearest PIONEER Service Centre.
Speed pulse wire is not connected.
Please be sure to connect the system
to the speed pulse wire. Accuracy is
not fully ensured without speed
pulse. The speed signal input (pink lead
wire) of the power cable is not con-
nected. To operate with 3D hybrid mode, con-
nect the speed signal input (pink
lead wire) of the power cable cor-
rectly. Although it can be operated
with Simple hybrid mode without
connecting the speed signal input,
the precision of the positioning will
be less accurate.
Vibration is detected. Please turn the
system power off and check the
installation. After checking, please
re-boot the system and press “OK”. While the vehicle is stationary, the
Navigation System is installed in a
place where the navigation unit may
be affected by a large vibration. Re-install the navigation unit of the
Navigation System in a place where
the navigation unit will not be
affected by vibration.
Direction of G sensor is not correct.
Please turn the system power off and
check the installation. After check-
ing, please re-boot the system and
press “OK”. Direction of G sensor is set incor-
rectly. See the “Installation Manual” and set
the direction of the Hide-away unit
correctly.
Gyro Sensor is not working properly.
Please consult your dealer or Pioneer
service centre. Abnormal output of Gyrosensor is
detected. Note down the error code shown on
the screen; turn off the power, and
then contact your nearest Pioneer
service facility.
Your route could not be found. If the distance to the destination is
too far and cannot be set. Change the destination to a location
that is closer and divide up the route.
Your journey can not avoid the speci-
fied area. If route setting cannot avoid speci-
fied Areas to Avoid. Choose whether or not to try setting
a route through the area.
Memory is full. If there are already 300 items when
you attempt to register an item in the
Address Book. Delete some destinations as appro-
priate.
Irregular character strings. Please
input again. A symbol that cannot be pronounced
was entered. Enter a word that can be pro-
nounced.
An error has occurred. Please note
the following error code and switch
power off. In the case of a system failure. Note down the error code shown on
the screen; turn off the power, and
then contact your nearest Pioneer
service facility.
DVD Player is overheating. Discon-
tinue until temperature drops. The built-in DVD drive has over-
heated. Cut the power off, and wait for a
while before turning the power on
again.
Message When What to do
Message Cause Action (See)
ERROR-02 Dirty Clean disc.
Scratched disc Replace disc.
ERROR-05 Electrical or mechanical Press RESET button. (“Hardware manual”
and refer to page 105 in this manual.)
DIFFERENT REGION
DISC (REGION ERR) The disc does not have the same region
number as this unit Replace the DVD video with one bearing the
correct region number.
NON PLAYABLE DISC
(NON-PLAY) This type of disc cannot be played by this
unit Replace the disc with one this unit can play.
The disc is loaded upside down Check that the disc is loaded correctly.
THERMAL PROTEC-
TION IN MOTION
(TEMP) The temperature of this unit is outside of
the normal operating range Wait until the unit’s temperature returns to
within normal operating limits.