Pioneer AVIC-X1 - Manual (Page 52)

50
Chapter 4
Editing the Navigation Utilities
NAVI
To clear values...
If you want to delete the learned results stored in
“Distance”, “Speed Pulse” or “Learning Sta-
tus”, touch the relevant result, then touch
“Clear”.
❒ This unit can automatically use two types of
sensor memory based on the outer dimen-
sions of the tyres.
Checking the connections of
leads and installation positions
Check that leads are properly connected between
the navigation unit and the vehicle. Please also
check whether they are connected in the correct
positions.
1
Touch “Information” in the Main menu,
then touch “Connection Status”.
The Connection Status screen appears. Either
“OK” or “NG” (or “No”) appears on the
screen, and the connection status of each
cable is shown.
1. Speed Pulse
The Speed Pulse value detected by this unit
is shown. “0” is shown while the vehicle is
stationary.
2. GPS Aerial
Indicates the connection status of the GPS
aerial, the reception sensitivity, and from
how many satellites the signal is received.
3. Installation Position
The Installation position of the navigation
unit is shown.
4. Hand brake
When the handbrake is applied, “On” is dis-
played. When the handbrake is released,
“Off” is displayed.
5. Power Voltage
The power supply (reference value) pro-
vided from the vehicle battery to this unit is
shown. If the voltage does not fall within the
range of 11 to 15V, check that power cable
connection is correct.
6. Illumination
When the headlights or small lamps of a
vehicle are on, “On” is displayed. (If the
orange/white lead is not connected, “Off”
appears.)
7. Back Signal
When the gear lever is shifted to “R”, the
signal switches to “High” or “Low”. (Which
of these is displayed depends on the vehi-
cle.)
Setting the Vehicle Dynamics
Display
You can change the values displayed by the
instruments on the left and right of the Sensor
View.
❒ Vehicle Dynamics cannot be displayed if
sensor initialisation is not complete.
1
Switch to the Vehicle Dynamics Display.
➲ Changing the map display mode ➞
Page 23
2
Touch the left or right instrument.
Touch keys are displayed.
3
Touch the items you want to display.
You can select the following items.
•Voltage
•Acceleration:
Acceleration in a forward direction is dis-
played. The + sign indicates acceleration
while the – sign indicates deceleration.
•Side Acceleration:
Acceleration in the lateral direction is dis-
played. The + sign indicates a left turn, while
the – sign indicates a right turn.
•Angular Velocity
1
2
3
4
5
6
7