Pioneer AVIC-X1 - Manual (Page 51)

49
Chapter 4
Editing the Navigation Utilities
NAVI
❒ You can only use standard characters (alpha-
bets of both cases: A-Z, a-z) and numbers (0-9)
for the file name of a background picture
(international (accented) characters cannot
be used).
❒ Pictures up to a maximum of 2048×1536 pix-
els can be used. We cannot guarantee a
proper operation for a picture bigger than this
size.
❒ Progressive format JPEG pictures cannot be
used.
❒ When changing a picture starts, do not cut off
the vehicle engine until the message inform-
ing the completion of changing a picture is
indicated.
❒ When the Navigation System is reset, or the
language setting is changed, the background
picture may change back to the original pic-
ture. (There is also a possibility that the sys-
tem will revert to the original picture for some
other reason). If this happens, set the back-
ground picture again.
Checking the Navigation Status
The navigation status, including the driving sta-
tus of a vehicle, positioning status by satellite,
learning status of the 3D sensor, and cable con-
nection status can be checked.
Checking sensor learning status
and driving status
1
Touch “Information” in the Main menu,
then touch “3D Calibration Status”.
The 3D Calibration Status screen appears.
1. Distance
Driving distance is indicated.
2. Speed Pulse
Total number of speed pulses is indicated.
3. Learning Status
Current driving mode is indicated.
4. Degree of learning
Learning situations of Distance, Right Turn,
Left Turn, and 3D detection are indicated by
the length of bars.
5. Speed
Speed detected by this unit is indicated.
(This indication may be different from the
actual speed of your vehicle, so please do
not use this instead of the speedometer of
your vehicle.)
6. Front and back G/Rotational speed
Accelerated velocity of your vehicle in front
/ back direction is indicated. Also, rota-
tional speed when your vehicle turns to left
or right is shown.
7. Inclination
Degree of slope of the street is indicated.
1
2
3
4
5 7 6