Bard TCS22-***-003 - Manual (Page 20)

2100-444-003A
Page 14
should close when door is closed. If a door switch
is not used a jumper should be placed across
this input.
This is a dry contact input only. Do not
connect any voltage source to these terminals. Do
not connect utility power to these terminals.
3.2.5 WIRING - TELEPHONE LINE
When the TCS22 is equipped with a
modem, an analog phone line should be connected
to the back of the modem in the jack labeled LINE.
This jack accepts a standard a RJ-11 six (6)
position modular phone plug.
3.2.6 WIRING - ETHERNET
When the TCS22 is equipped with an
Etherlink communications module, The
LAN/WAN should be connected to the back of the
module in the jack labeled Ethernet. This jack
accepts a standard a RJ-11 eight (8) position
modular phone plug.
The Etherlink communications module
requires a dedicated IP address. This must be
programmed by the end user via a computer and
RS232 cable at the time of connection to the
network. The cable is provided with the TCS22.
Specific configuration information is
provided with the EtherLink Module in a separate
document.