Bard TCS22-***-003 - Manual (Page 41)

2100-444-003A
Page 35
5.3.4 Setpoints Screen
The Setpoints screen displays the following information about the controller.
Occupied Cooling Setpoint Current Setpoint
Unoccupied Cooling Setpoint Current Setpoint
Occupied Heating Setpoint Current Setpoint
Unoccupied Heating Setpoint Current Setpoint
High Temperature Alarm Setpoint Current Setpoint
Low Temperature Alarm Setpoint Current Setpoint
High Humidity Alarm Setpoint Current Setpoint
Low Humidity Alarm Setpoint Current Setpoint
Dehumidification Setpoint Current Setpoint
Free Cooling Enthalpy Setpoint Current Setpoint
Free Cooling Dry Bulb Setpoint Current Setpoint
From this menu you can display the current setpoint and, with the proper authorization, change
the current setpoints. The values displayed for each of these points is updated every ten (10) seconds.
Pressing the <Up> or <Down> key will scroll up or down respectively through the screen on
page 39 showing four lines at a time.
To change a set point scroll up or down until the setpoint that is to be changed is visible on the
screen. Press the <F1> key. If more then one setpoint is shown on the screen use the <Up> and <Down >
keys to highlight the setpoint to be changed. Press enter. Use the <Left> and <Right> keys to move the
underline to the digit you wish to change. Use the <Up> and <Down > keys to increment or decrement
the digit to the correct value. Once done with changing the digits press <Enter> to accept the change. If
the value was accepted the new setpoint will be shown. If the setpoint was not accepted the value will
flash all asterisks. This indicates that the value downloaded was out of the acceptable range for this
setpoint. See section 4.2.11 for the setpoint ranges or the individual sections below.
If you do not have authority to change the setpoints the setpoint value will not be highlighted. A
supervisor authority level is required to change any setpoints. If you have authority to change the
setpoint the setpoint value will be highlighted after pressing the <F1> key.
To enter a password, press <F2> key at any time. See the password section in this manual for
proper password entry method.