Barco CINE7 R9010050 - Manual (Page 103)

10. Programmable Function Keys
10. PROGRAMMABLE FUNCTION KEYS
10.1 Programming a Function Keys
What can be done with these keys?
The five function keys on top of the remote control can be programmed as short cut keys (quick access) to almost any adjustment
function. See list further in this chapter.
How can a Function key be programmed?
A function key can only be programmed when in the service menus.
1. Scroll through the menus until the desired function is on the menu.
2. Select this function by pushing the cursor keys up or down.
3. Press the desired function key for this function.
The following message : "Programming Function Key Fx" will be displayed.
The message will disappear automatically and the function key is programmed.
4. Leave the adjustment mode by pressing ADJUST.
5. The function key is available in the operational mode.
Example programming horizontal phase on key F4
1. Press ADJUST to enter the main menu. (menu 10-1)
2. Push the cursor key ↑ or ↓ to select Service mode.
3. Press ENTER to go into the adjustment menus.
A warning will be displayed. (menu 10-2)
4. If qualified, press ENTER otherwise press EXIT and call for technical assistance.
5. Select Random Access by pushing the cursor keys
↑
or
↓
.
6. Press ENTER to display the Random Access mode menu. (menu 10-3)
7. Push the cursor key ↑ or ↓ to select Geometry.
8. Press ENTER to display the Geometry menu. (menu 10-4)
9. Push the cursor key ↑ or ↓ to select H PHASE. (menu 10-5)
10.Press F4 to program this key.
11.Press ADJUST to return to operational mode.
MAIN MENU
Image control
Iris control
Sound control
Function keys
Service menus
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 10-1
WARNING
RISK OF INCORRECT
ADJUSTMENT OF THE
PROJECTOR.
The following
SERVICE menus
are reserved to,
and to be performed only
by qualified personnel !
If qualified, press
<ENTER> to continue, or
if not, <EXIT> to return.
Menu 10-2
ADJUSTMENT MODE
Select a path from below :
IRIS
GUIDED
RANDOM ACCESS
INSTALLATION
SERVICE
Source 01
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 10-3
RANDOM ACCESS
ADJUSTMENT MODE
PICTURE TUNING
GEOMETRY
CONVERGENCE
COLOR SELECT
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 10-4
GEOMETRY
H PHASE
RASTER SHIFT
LEFT-RIGHT (E-W)
TOP-BOTTOM (N-S)
SIZE
V LINEARITY
BLANKING
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 10-5
R5976584 BARCO CINE7 26022003 99