Bacharach AGM300 User Manual
Bacharach Safety
Advertising
This manual is related to the following products:
Table of contents
Document Outline
- Front Cover
- Introduction
- Safety Precautions
- Warning Statements
- Caution Statements
- Hazard Symbols on Monitor
- Functional Overview
- AGM300 Installation
- AGM300 - Installation Considerations
- AGM300 - Mounting Instructions
- AGM300 - Connecting Air Lines
- AGM300 - Interior Schematic
- AGM300 - Electrical Wiring
- AGM300 - Connecting Communication Devices
- Ammonia Display Module (ADM800) Connection
- Integrating with Building Management Systems
- Larger Integrated Systems
- Changing Terminator Settings
- Node Address DIP Switch Settings (Refer to Multiple AGM's and Connecting to a Building Management System)
- Personal Computer (Refer to AGM300 PC Software Section)
- Multiple AGM’s
- Connecting to a Building Management System
- AGM300 - PC Software
- Programming the AGM300 Using PC Software
- Saving the AGM300 Program to a Disk or Drive
- To Open a Saved Program
- To Send a Saved Program to an AGM300
- Trend Data
- To Convert the TREND Text File to a Microsoft Excel File
- To Save and Print the AGM300 Software Screen, Alarm Log, Fault Log, or Diagnostic Screen
- USB Type Laptops
- AGM300 - Current Loop Interfaces
- AGM300 - Connecting External Alarms
- ADM800 Installation
- ADM800 Operation
- ADM800 - Overview
- ADM800 - Screen Displays
- ADM800 - System Programming
- ADM800 - Setup Programming
- Setting the Clock
- Navigating to the 1st ADM Setup Screen
- Contrast
- Number of AGM Units
- AGM Baud Rate
- Audible Alarm
- Enabling Building Management System Connection
- Building Management System Stop Bits
- Building Management System Baud Rate
- Password
- Navigating to the 2nd ADM Setup Screen
- Setting Relay Parameters
- AGM Node Address
- AGM300 - Setup Programming
- ADM800 - Zone Setup Programming
- General Operation
- Working with Alarms
- Working with the Trend Screen
- Working with System Faults
- Working with the Calibration Screen
- Working with the Diagnostic Screen
- Service Mode
- Appendix
- AGM300 / ADM800 Maintenance
- Optional Accessories
- ADM800 - Logic Diagram
- RS-485 Communication Protocol
- AGM300 MODBUS RTU Operation
- Overview
- Protocol Details
- Notes on AGM300 Polling
- Notes on Network Topologies
- Key Comm Protocol Parameters
- Summary of Registers
- Data Type Abbreviations
- Fault Flag Structure uses bitwise access to 16 bit word as defined below:
- Notes on Alarms and Alarm Acknowledge
- Notes Concerning the AGM300 Hold Mode
- To Release the Zone Hold Use the Following Sequence of Steps
- Notes Concerning the AGM300 Service Mode
- To Release the Unit from Service Mode Use the Following Sequence of Steps
- MODBUS EXCEPTION RESPONSES
- WARRANTY and SERVICE
- AGM300 - Specifications
- ADM800 - Specifications