Philips Kaffeevollautomat - Manual (Page 11)

 Press the ^ or % button to select the desired coffee strength.
 Press OK when the display shows the desired coffee strength.
 Place 1 cup under the coffee spout to make 1 cup of coffee or  cups
to make  cups of coffee.
For creamier coffee, pull the spout downwards to bring it as close to the
cups as possible.
Tip: To keep the coffee hot longer, preheat the cups you use. Especially heat
up thick cups, as they absorb a lot of heat. To preheat the cups, put them on
the cup warmer tray when the appliance is switched on or rinse them with hot
water before use.
5 Press the button for short coffee, for standard coffee or for long
coffee.
Press the button once for 1 cup or twice within 2 seconds for 2 cups.
You can interrupt the brewing process at any time by pressing the
button for short coffee, for standard coffee or for long coffee, as
previously selected.
If the coffee comes out one drop at a time, not at all or too fast, adjust
the grinding coarseness (see section ‘Adjusting the coffee mill’).
You can also change the standard amount of coffee the appliance
brews, see section ‘Changing the coffee quantity for espresso’ below.
The appliance grinds the beans and brews coffee.
Once the set amount of coffee has been brewed, the appliance
automatically stops brewing and ejects the coffee grounds into the
waste bin.
After a few seconds, ‘READY TO USE’ appears on the display to
indicate that you can brew the next cup of coffee.
6 If the message ‘EMPTY WASTE BIN!’ appears, remove the waste
bin and empty and clean it.
Note: The message ‘EMPTY WASTE BIN!’ appears after every 14 cups. When
it appears, you cannot brew coffee again until you empty and clean the waste
bin.
1 Open the service door at the front by pulling the latch.
-
-
-
,
,
,
EnglisH 11