Philips Kaffeevollautomat - Manual (Page 12)

2 Remove the drip tray and empty and clean it.
3 Remove the waste bin, empty it and clean it thoroughly.
4 Reinsert the waste bin, reattach the drip tray and close the service
door.
Note: Keep in mind that when you remove the drip tray, you must empty
the waste bin, even if it is not completely full. If you don’t do this, the coffee
grounds in the waste bin will exceed the maximum level and block the
appliance.
Never remove the water tank when the appliance is brewing coffee. If
you do, the appliance stops brewing and the following messages appear
on the display: ‘GROUND TOO FINE! Adjust mill’ and ‘OPEN STEAM
KNOB!’.
Take the following steps if you have removed the water tank while the
appliance was brewing coffee:
1 Reinsert the water tank.
2 Place a cup under the steam pipe and turn the steam knob to ‘ON’.
Water runs out of the steam pipe for a few seconds. Then set the
steam knob to ‘OFF’.
3 If the appliance malfunctions, follow the instructions in chapter
‘Troubleshooting’. If you cannot solve the problem, contact the
Customer Care Centre in your country.
 Press the on/off button 3 to switch off the appliance.
When you switch off the appliance, it performs an automatic flushing
cycle.
During the flushing cycle, some hot water flows out of the coffee spout
into the drip tray below to clean the whole system.
Brewing espresso from ground coffee
Only add ground coffee after you have switched on the appliance.
Otherwise the ground coffee will be dispersed inside the appliance.
Only use the measuring spoon supplied to add ground coffee.
,
EnglisH
1