SkyTrak 10054 Operation Manual - Manual (Page 104)

102 Model 10054 Rev. 11/03
Emergency Operations
1. Clear the area of any unnecessary personnel.
2. Place the travel select lever in (N) NEUTRAL, move the neutral lock
lever to NEUTRAL LOCK position and engage the parking brake
switch.
3. Block all four wheels.
4. If the load is in a position where it can be removed safely, com-
pletely remove the load from the carriage and/or attachment; other-
wise, leave the load in place.
5. Temporarily block up or support the outer boom.
6. Replace the failed hydraulic line with a new part. The hydraulic lines
are:
• Boom Lift Line (1)
• Boom Lower Line (2)
• Boom Extend Line (3)
• Boom Retract Line (4)
7. Check the hydraulic oil level, add oil if needed.
8. Remove the blocking or support from the outer boom.
9. Return to the cab, fasten your seat belt and start the engine.
10. Tilt the carriage and/or attachment upward if necessary for clear-
ance before retracting the boom.
11. Slowly retract the boom.
STEP 1
WARNING:
DO NOT get under a raised boom unless the
boom is blocked up. Always block the boom before doing any ser-
vicing that requires the boom to be up.
WARNING:
Wear protective clothing and proper eye pro-
tection when working with or around hydraulic oil. Wait for hydrau-
lic oil to cool before attempting to repair the failure. Hot hydraulic
oil can cause severe burns and other serious injury.