SkyTrak 10054 Operation Manual - Manual (Page 124)

122 Model 10054 Rev. 11/03
General Maintenance
To change elements:
1. Pull the air cleaner cover lock (1) OUT, turn the air cleaner cover (2)
counterclockwise and remove the cover from the air cleaner canis-
ter (3).
2. Remove the primary element (4). Inspect the element for damage.
Damaged elements should not be reused.
3. Thoroughly clean the interior of the air filter canister (5) and vacua-
tor valve (6).
4. If replacing the inner element (7) at this time, carefully slide the ele-
ment out. Always discard this element and replace with a new ele-
ment.
5. Slide the new primary element over the inner element making sure
the sealing edge is flush with the base of the air cleaner.
IMPORTANT! DO NOT apply any type of petroleum product to the sealing
surface of the filter in an attempt to get a more positive seal. This will cause
sealing surface damage and allow dirt to by-pass the filter. Use liquid
dishwashing soap (Ivory, Dawn, etc.) on the seal of the filter only.
6. Position the canister cover (8) in place, turn clockwise to lock into
position and secure in place by pushing the air cleaner cover lock
(9) all the way in.
OH3390
1
2
3