SkyTrak 10054 Operation Manual - Manual (Page 188)

186 Model 10054 Rev. 11/03
Test Procedures
Stabil-TRAK System Test Procedures
Step 1
a. Place the vehicle on a level surface with 0° sway.
b. Have the boom fully retracted and horizontal.
c. Place an 8" (203 mm) wood or cement block in front of the
front left tire.
d. Enter the vehicle.
e. Fasten the seat belt.
f. Turn the key to the RUN position.
g. Check to be sure the Stabil-TRAK light is OFF.
Step 2
a. Start the engine.
b. Turn the parking brake switch OFF.
c. Move the range select lever to (1) FIRST gear.
d. Move the travel select lever to the (F) FORWARD
position.
e. Drive the vehicle up on the block.
f. Use the frame sway control to level the vehicle back to 0°.
Step 3
a. Depress the service brake pedal.
b. Move the travel select lever to the (N) NEUTRAL position.
c. Raise the boom to exactly 60°. The Stabil-TRAK light
should come ON when the boom angle is at about 40°
and remain ON.
Step 4
a. Use your left foot to depress the service brake pedal.
b. With the range select lever in (2) SECOND gear, move
the travel select lever to the (R) REVERSE position.
c. Ease your left foot partially off the service brake pedal,
make sure that the Stabil-TRAK light remains ON.
d. With your right foot, increase the engine rpm slightly, as
necessary, just enough to back the vehicle off the block.
While backing off the block, the front left tire should
remain off the ground.
FRE
E
PIV
O
T M
O
DE
LOCKE
D M
O
DE
Se
rv
ic
e
Br
a
k
e
T
e
s
t
OH2500