SkyTrak 10054 Operation Manual - Manual (Page 172)

170 Model 10054 Rev. 11/03
General Maintenance
7. If the measurement is more than 14.25" (362 mm), tighten the inner
boom retract chain locknut (1) located on the bottom of the primary
intermediate boom (2). Extend the boom far enough to expose the
inner boom retract chain locknut (1).
8. Start the vehicle, with the outriggers lowered completely, cycle the
boom in and out several times. Then with the boom horizontal,
retract the boom completely. Turn the vehicle OFF.
9. Recheck the measurement at the rear of the boom between the top
rear edge of the secondary intermediate boom and the top rear
edge of the inner boom. If the measurement is still more than the
ranges listed above, repeat steps 7 through 8.
NOTE: If, by adjusting the inner boom retract chain locknut, you cannot get
the measurement within the range of 13.75" (349 mm) - 14.25" (362 mm),
the boom may require extensive adjustment and/or repair. Contact your
local Sky Trak Distributor.
OH0660
2
1