SkyTrak 10054 Operation Manual - Manual (Page 150)

148 Model 10054 Rev. 11/03
General Maintenance
5. Pressurize the park brake with the pressurizing unit. Close the
pump needle valve on the pressurizing unit.
6. Working through the level plug hole (1), carefully use a screwdriver
to spread the brake disks apart.
IMPORTANT! DO NOT damage the surfaces of the brake disks when
spreading the brake disks.
7. Using a feeler gauge, check the gap (2) between the brake disks
(3). If the gap is greater than .26" (6,75 mm), replace the brake
disks.
NOTE: If the brake disks are worn beyond .26" (6,75 mm), the brake disk
must be replaced on both sides of the axle at the same time.
8. Repeat step 6 and step 7 for the other side of the axle.
9. Continue with step 6 of “B. Axle Oil Change” on page 145.
1
MT2850