SkyTrak 10054 Operation Manual - Manual (Page 191)

Test Procedures
189 Model 10054 Rev. 11/03
To test the function of the Boom/Outrigger Interlock System perform the
“Stabil-TRAK System Test” begining on page 185 before performing the
following test.
Boom/Outrigger Interlock System Test
Boom/Outrigger Interlock System Test Procedures
Step 1
a. Place the vehicle with no load on a hard, level surface
such as blacktop or concrete.
b. Fasten your seat belt.
Step 2
a. With the outriggers in the raised position and the boom in
a horizontal position, extend the boom. The boom should
extend until the letter “E” appears and then should STOP.
If the boom extends beyond the letter “F”, retract the
boom fully and have the system repaired before using the
vehicle again.
b. Attempt to frame sway the vehicle to the right and left; it
should frame sway normally.
Step 3
a. Lower both outriggers to the ground. DO NOT lift the front
wheels of the vehicle off the ground at this time. The
Stabil-TRAK light should come ON when the outriggers
are lowered.
b. With the boom still in a horizontal position, extend the
boom.
c. Attempt to raise both outriggers; they should not rise. If
the outriggers rise, STOP and retract the boom and have
the system repaired before using the vehicle again.
d. If the outriggers cannot be raised, attempt to lower the
outriggers fully until both front wheels are off the ground;
the outriggers should lower.
Step 4
a. Place the travel select lever in the (F) FORWARD position
and the gear select lever in the (1) FIRST gear position.
b. Attempt to accelerate the vehicle; the vehicle should not
move.
c. If the vehicle attempts to move, STOP and have the
system repaired before using the vehicle again.
BOOM
E
X
TE
ND
MO
DE
1
BO
O
M
E
X
TE
ND
MO
D
E
2
BOOM
E
X
TE
ND
MO
DE
3