SkyTrak 6042 Operation Manual - Manual (Page 141)

General Maintenance
139 Model 6042 Origin 2/04
3. Allow the transmission to cool.
4. Place a receptacle under the transmission drain plug (3). Remove
the drain plug and allow the Universal Tractor Fluid to drain into the
receptacle. Transfer the used oil into a suitable container with a
cover and label the container as used oil. Dispose of properly.
5. Clean and re-install the drain plug (3) into the transmission housing.
6. Remove the filter (4) from the filter mount on the front side of the
transmission (5). Dispose of the filter properly. Clean the mating
surface where the filter mounts.
7. Apply a thin film of clean Universal Tractor Fluid to the new filter
gasket. Carefully install a new filter.
8. Remove the dipstick (6) and fill with Universal Tractor Fluid approx-
imately 2.6 gallons (9,8 liters). Re-install the dipstick.
9. Check the transmission level and add Universal Tractor Fluid as
required following the procedures outlined in “Transmission Oil
Level Check” on page 137.
10. Reassemble the transmission covers and secure in place with the
six capscrews and washers. Tighten securely.
OH2380
3
4
6
5