SkyTrak 6042 Operation Manual - Manual (Page 178)

176 Model 6042 Origin 2/04
Test Procedures
If steps 1 through 9 prove positive, the Stabil-TRAK system is functioning
properly and the vehicle can be returned to service. If any of these steps
indicate that the Stabil-TRAK system is not functioning properly, contact
your local Sky Trak Distributor immediately to repair the system.
Step 8 (Continued)
e. The Stabil-TRAK light should go OFF.
f. The front left tire should return to the ground while the
vehicle travels in reverse.
g. Depress the service brake pedal to stop the vehicle.
Step 9
a. With the service brake pedal depressed and the boom
angle at exactly 45°, move the range select lever to (3)
THIRD gear.
b. Move the travel select lever to (F) FORWARD.
c. Release the service brake pedal to deactivate the Stabil-
TRAK system. The Stabil-TRAK light should go OFF.
d. Slowly drive the vehicle forward against the block to stop
the vehicle from moving forward.
e. With the front left tire against the block, frame sway the
vehicle no more than 5° to the left.
f. Check that the front left tire remains on the ground. It is
normal for the front left tire to raise slightly when swaying
to the left, but the tire should immediately lower when the
frame sway function is stopped.
g. Frame sway the vehicle back to 0° and pause briefly.
h. Frame sway the vehicle no more than 5° to the right.
i. Check that the front right tire remains on the ground. It is
normal for the front right tire to raise slightly when
swaying to the right, but the tire should immediately lower
when the frame sway function is stopped.
j. Frame sway the vehicle back to 0°.
k. Depress the service brake pedal.
l. Shift the travel select lever to (N) NEUTRAL.
m. Lower the boom.
Stabil-TRAK System Test Procedures
SLO
W
P
IV
O
T
M
O
D
E
SL
O
W
PI
V
O
T
MO
DE
LOCKE
D M
O
DE