SkyTrak 6042 Operation Manual - Manual (Page 74)

72 Model 6042 Origin 2/04
Operation
Quick Attach
This vehicle is equipped with a quick attach system for easy attachment
changing.
Attachment Removal
Be sure you are performing this procedure on level ground.
1. Place the travel select lever in (N) NEUTRAL, come to a complete
stop, move the neutral lock lever to NEUTRAL LOCK position and
engage the parking brake switch.
2. Extend the boom approximately 10 feet (3 meters) and tilt the car-
riage backward.
3. Exit the vehicle using the hand holds.
NOTE: If you are removing a standard carriage with forks, spread the forks
apart on the carriage shaft. This will provide the carriage adequate support
to stand alone.
4. Raise the quick attach pin lock lever (1) and pull out the pin (2) at
the bottom of the quick attach link (3).
5. Return to the operators compartment, fasten the seat belt and
lower the attachment to the ground in a level position. Tilt the
attachment forward. This will rotate the quick attach link back away
from the attachment.
6. Lower and then retract the boom until the attachment pivot pins
have disconnected from the attachment.
OS0331
2
1
3