SkyTrak 6042 Operation Manual - Manual (Page 88)

86 Model 6042 Origin 2/04
Operation
10. A body belt and lanyard is to have an attaching point for freedom of
movement, and its length is to limit free fall to 5 feet (1500 mm)
measured from the point of attachment to the operator. The com-
plete system shall be capable of withstanding three consecutive
drop tests to simulate a 250 lb (113 kg) person falling 6 feet (1800
mm) without allowing the test weight to fall free to the ground. A
deceleration device may be included.
11. Lanyards, when provided, shall be arranged so as not to cause a
tripping hazard.
12. Body belts, when provided, should have a width of at least 1.75 in.
(44 mm).
13. Structural safety factor - all load supporting structural elements of
the work platform shall have a structural safety factor of not less
than 2 to 1 based on the minimum yield strength of materials used.
Capacity Limitations
The combined mass (weight in pounds) of the platform, load and personnel
shall not exceed one-third (33%) of the capacity of the related load center
position indicated on the capacity chart. Refer to “Using The Capacity
Chart” on page 74.
Preparation and Set-up
1. DO NOT alter or modify the work platform in any manner.
2. Make sure that the work platform is securely attached to the quick
attach or forks. Follow the platform manufacturer’s instructions.
3. Make sure the platform, carriage and forks are secured to prevent
them from pivoting from side to side.
4. On side tilt or swing carriages, the carriage must be centered and/
or leveled horizontally and vertically. The hydraulic system quick
disconnects must also be disconnected and plugged and the car-
riage securely fastened to prevent any tilting or side to side swing-
ing motion.
5. Ensure the vehicle has a firm footing and is level.
WARNING:
Never allow anyone to alter or modify any part
of the work platform. Any modification to the platform which could
result in serious personal injury to anyone on the platform.