SkyTrak 6042 Operation Manual - Manual (Page 91)

Operation
89 Model 6042 Origin 2/04
Numerous attachments, marketed by JLG are available for this vehicle. The
capacity charts attached to this vehicles dash are to be used with Sky Trak
approved attachments only. Hydraulically powered attachments must only
be used on vehicles equipped with auxiliary hydraulics.
IMPORTANT! This vehicle is intended for the function of lifting only. This
vehicle is not designed to PULL, TOW or DRAG other objects.
JLG makes no representations or warranties, expressed or implied, as to
the design, manufacture or fitness for use with this vehicle of any third party
source attachment. This vehicle is not intended to be used and should not
be used with an attachment that would alter the center of gravity or stability
of this vehicle. JLG assumes no liability for any third party attachment that
would alter the center of gravity or stability.
IMPORTANT! DO NOT use unapproved attachments.
Following is a list of some of the attachments available through JLG for this
vehicle model:
• 48" Standard Carriage
• 60" Standard Carriage
• 72" Standard Carriage
• 1-1/4 Cubic Yard Bucket
The standard capacity chart on page 77 is applicable for the above listed
attachments.
The attachments listed below are supplied with their own individual capacity
chart:
• 48, 60 & 72" Side Tilt Carriage (page 78).
• 52 & 72" Swing Carriage (page 79).
• 12 Foot Truss Boom (page 80).
• 3 Foot Truss Boom w/Winch (page 81).
Hydraulically actuated attachments also have a maximum hydraulic
pressure rating. Ensure that the maximum rated hydraulic pressure of the
attachment is equal to or slightly greater than 3,000 psi (206,8 bar), which is
the maximum pressure of the vehicle’s auxiliary hydraulics at the quick
disconnect couplers.
Using Other Attachments