SkyTrak 6042 Operation Manual - Manual (Page 58)

56 Model 6042 Origin 2/04
Operation
The engine is equipped with a 120 volt 750 watt block heater. Block heaters
are recommended when temperatures drop below 10° F (-12° C).
Temperature ranges will vary when using different oil weights. Consult the
engine manufacturer’s manual for other variables.
FOR ENGINES EQUIPPED WITH OPTIONAL COLD STARTING AID
The engine is equipped with a grid heater inside the induction manifold. If
the temperature drops below 40° F (4° C) the air-intake heater system will
be activated when the ignition switch is turned to the RUN position. When
the system is active the air-intake heater light will illuminate on the front
dash. DO NOT turn the ignition switch to START until the air-intake heater
light goes OFF.
At temperatures below -10° F (-12° C), operate the engine at moderate
speeds for 5 minutes before full loads are applied.
1. Enter the cab using the hand holds and adjust the seat for comfort-
able operation.
2. Adjust the mirrors to obtain the best rear view from the operator’s
position.
3. Fasten the seat belt.
4. Make sure the parking brake switch is ENGAGED.
5. Place the travel select lever in (N) NEUTRAL and move the neutral
lock lever to NEUTRAL LOCK position.
Cold Starting
WARNING:
This diesel engine uses a grid heating system
inside the induction manifold. DO NOT use ether or any high
energy fuels to assist starting. An explosion may cause death or
serious personal injury or engine damage.
WARNING:
DO NOT start the engine unless you are in the
seat with the seat belt fastened around you. Death or serious per-
sonal injury could result if the belt is not securely fastened.